Product Details:
Payment & Shipping Terms:
|
Model: | Hyno Prius 202.1 | Type Of Battery: | NiMH Battery |
---|---|---|---|
Cycle Life: | ≥1000cycles | Charge Retention Performance (28days Charge Retention Rate): | ≥80% |
Working Temperature Range: | -20℃ To +55℃ | Application: | Automative Car Battery |
High Light: | toyota prius battery cell replacement,prius hybrid battery replacement cells |
Another quick note on 12v batteries—most of the time these are not the usual flooded acid batteries you may be used to. You’re more likely dealing with an Absorbed Glass Mat battery or AGM battery. Hybrid manufacturers (Toyota mainly) are very fond of putting the 12v battery inside the car. Why? No idea. AGM batteries don’t off-gas as badly as flooded batteries—if you find a battery mounted inside the car, odds are it’s AGM. AGM batteries can’t handle the aggressive charging that normal batteries can and you have to use a special charger set to AGM mode, or you’ll cook the expensive battery. If you don’t have an AGM mode, then just go low and slow with your charger.
Tests should be done within one month of receiving the goods under the following conditions.
Test condition
Temperature:20±5℃
Relative Humidity:65±20%
Atmospheric Pressure:86~106kPa
Standard charge discharge specification
Discharge: 6000mA (1C) to 168.0V
Charge: 6000mA (1C)×1hrs,1200mA (0.2C)×1hrs
Discharge: 6000mA (1C) to 12.0V
Item | Specification | |
Dimension | Length (mm) × Width (mm) × Height (mm) | 550 x 294 x 110 |
Approximate Weight (kg) | 30 | |
Typical Capacity(mAh) | 6500 | |
Minimum Capacity (mAh) | 6000 | |
Nominal Voltage (V) | 201.6 | |
High Temperature Performance ( 55℃ 1C discharge rate) | ≥90% | |
Low Temperature Performance (-20℃ 1C discharge rate) | ≥85% | |
Charge Retention Performance (28days charge retention rate) | ≥80% | |
Working Temperature Range | -20℃ to +55℃ | |
Cycle Life (C/2 charge, 1C discharge) | ≥1000cycles | |
The SOC of our battery pack is 60%~80% when leaving the factory, in long-term storage, battery should be stored in a charged state (usually the SOC is 80%). Have a charge and discharge maintenance to battery pack when the storage time is over 6 months or battery module’s voltage is 15V,to prevent the battery performance’s decline caused by the self-discharge. The maintenance regulations are as follows:
Notes: Installing this product should only be attempted by a qualified technician, the voltage of the battery pack is very high, which has the shock hazards, so when installing the battery pack, you should wear insulating gloves and use insulated handle tools.
Hunan Hi-soon Supply Chain Co., Ltd reserves the right to change and revise Product specification without any advance notice.
Contact Person: Aaron Xiang
Tel: 008615675823200